Some things are just better together. I feel this way about gold and marble. I can’t seem to get enough of this luxurious pairing, but the cost (not to mention the weight!) can add up quickly, so I made it my mission to find a way to create the look for less.
Below you will find instructions on how to create a gold and faux marble shelving unit for $70 to $110 depending on the size of the unit you choose. Buying a genuine marble and gold shelving unit at a store will likely cost upwards of $1000, so this DIY will save you a ton.
The quantities listed below are for the large Vittsjo unit. If you Choose the skinnier or shorter versions you can likely cut one roll of marble contact paper and one can of spray paint. The project can be completed in less than 2 hours.
Here’s what you need:
- Ikea Vittsjo shelving unit or another similar model ($79.00). They also have skinnier or shorter models for $49 or $59 respectively.
- 3 cans of Rust-Oleum Gold Spray Paint ($3.76 each)
- Drop cloth or tarp (to protect area from gold spray paint mist, $1.98)
- 2 rolls of faux marble contact paper ($7.57 each). To save money you can just coat the visible sides of the shelves in the paper which would allow you to cut one roll)
- Ikea Shower Squeegee ($1.99 and you can use it on your shower door afterwards!)
For safety I also recommend a reusable respirator to avoid breathing in the paint fumes and rubber or gardening gloves to keep the paint off of your hands.
After assembling the shelving unit, remove the shelves and set the unit on top of the drop cloth. It’s easier to apply the spray paint in a controlled area like a garage where you aren’t affected by the wind, but make sure you have adequate ventilation (leave door open).
Follow the directions on the paint can. Don’t hold the can too close to the shelving unit and keep moving it while you spray or you will get drip marks. If you get drip marks, wipe them off and respray the area. I did one coat and touched it up within an hour as needed. Let it dry for 10 hours before attempting to move it. I noticed that the paint chips somewhat easily so be careful and keep extra paint for touch ups.
Next measure and apply the contact paper to the bottom and top shelves. Use the shower squeegee to smooth the paper and prevent bubbles. If you get bubbles you can pull the paper back and start again. I left the three glass shelves as is, but you can technically apply the paper to the glass shelves as well. You would need three additional rolls of contact paper.
My assistant surveying the finished product :)